To install a map on a Power Commander V fuel tuner, you will need to download the Dynojet Power Commander software using a Windows computer (or a Mac running Windows). Once you install the software, it is easy to download maps from the Dynojet.com website.
No, the Power Commander is a fully sealed unit. It is not necessary to cover the unit to protect it from water.
yes you need a powercommander for a dyno tune. That is what they tune that controls how much fuel is pumped into your engine. You also should install block off plates. It may help with some of the popping as well.
The Power Commander is a tuning tool to adjust fuel, and on some models ignition timing. Just adding a Power Commander to a completely stock vehicle usually does not increase peak horsepower. It usually will improve drivability, throttle response, and mid-range horsepower and torque.
Compare with similar items
| This item Dynojet (19-001 Power Commander V Fuel Injection Module | Dynojet (17-013 Power Commander V Fuel Injection Module |
|---|
| Add to Cart | Add to Cart |
| Customer Rating | 5.0 out of 5 stars (1) | 5.0 out of 5 stars (1) |
| Price | $39999 | $34999 |
| Sold By | Racing Performance | Racing Performance |
Yes, you can move your PCV to the other bike as both bikes use the same one (Part # 15-011). You will however need to go to the Power Commander website and download a new map to the PCV that matches your current setup for the 2012.
Hold down all three buttons on the face of the Power Commander unit and turn on the bike's ignition. Release all the buttons once the engine is idling normally. The Power Commander manual recommends waiting approximately 20 seconds before making any adjustments.
the only time you need mapping (power commander) is if you do anything to change the air/fuel ratio. the reason a slip-on does not need a power commander is because the exup valve (a servo controlled butterfly valve in your exhaust) is still in place and it manages exhaust flow and back pressure.
No. The connectors are different for each injection system on each bike. In theory you can snip the old connectors off and wire up new ones.
Once installed, the AutoTune kit monitors the air/fuel ratio. It then sends this information to the Power Commander V and automatically corrects it as you ride, letting you feel the changes as they happen.
Featuring a plug-and-play kit, Power Commander V can be installed discreetly underneath your seat, ensuring your ride looks as good as it runs.
Power Commander III: How to Reset a PCIIIUSB
- Connect it to the software and power it up using the 9-volt adapter.
- Once you have communication established, go to the "Tools" menu and select "Environmental Options".
- A window will appear that has a black rectangular button at the bottom that reads "Reset Power Commander".
They only last about 10 minutes.
- Under "Tools" menu, select the "Environment Options" menu.
- The "Environment Options" dialog opens.
- At the bottom of the Environment Options box, the "Reset Power Commander" button will now appear.
- Click the "Reset Power Commander" button.
PCV Software will update the attached device.
Updating the Firmware on Power Commander V
- Select Power Commander Tools > Configure > Update Firmware.
- Browse to the location of the firmware file.
- Select the file.
- Click Open.
